Why DCS requires signal isolators

With the improvement of the level of production automation, the system environmental problems are gradually increasing. Especially for some large companies, it is necessary to fully consider the safety and reliability, and it is necessary to strictly follow the regulations to ensure the normal operation of the production. If the signal isolators are omitted, the signal isolators signal distributors produce high-precision signal isolators and signal distributors. The production process is forced to be interrupted or production accidents occur, resulting in economic losses and No one can bear the responsibility of the accident. Therefore, in normal production, dcs equipped with signal isolators is necessary. Then Xiaobian will talk to you about the benefits of DCS with signal isolators.

If the analog input board of the DCS is an isolation board, the isolation performance of the general isolation board is not as good as that of the signal isolator. (The isolation strength of the signal isolator can reach 2500V or more, and the isolation board is still at 1000V and 1500V. At this level), if it is a isolation board (or isolation device), then think about it, once a board fails, how to maintain it?

I am afraid that the entire board will be removed, which will inevitably affect other channels. The signal isolator does not need, one channel and one isolator. Once the fault occurs, it can be directly replaced by a certain channel. Moreover, one input, one output, one input, two output, two input and two output signal isolators are also provided on the signal isolator. With over-current, over-voltage, surge and reverse-connection protection for signals, these DCS analog boards are not available or are not fully equipped. Many automatic control systems, when designing and installing, in order to save costs, no isolators are used. In the final debugging, the interference of the measurement channel is difficult to remove. Finally, the signal isolators must be used. Some engineers countered that my system There is no signal isolator used, and it works as usual. Indeed, there are signal isolators used in the signal path. In some cases, the signal isolators do not affect the operation of the automatic control system (specifically, the negative effects on the automatic control system due to the absence of the isolator are not clearly manifested). This is the general case, but when strong interference, lightning strikes, short circuits, etc. occur, you know the great role of the signal isolator.

China leading manufacturers and suppliers of Brushless Dc Servo Motor,Brushless Dc Servo Motors, and we are specialize in Dc Servo Motor In Robotics,Servomotor For Vehicle Robot, etc.

Motor Voltage: 12V 24V 48V

Motor Power: 100w 200w 400w 500w 750w 800w 1000w 1200w 1500w 2000w 3000w

Motor speed: 1500rpm 3000rpm

Encoder: 2500ppr, optical, if you need other type encoder, please advise.

The motor also be named pmsm motor, permanent-magnet synchronous motor, sinusoid wave, be widely used in robot vehicle.

Brushless Dc Servo Motor

Brushless Dc Servo Motor,Brushless Dc Servo Motors,Dc Servo Motor In Robotics,Servomotor For Vehicle Robot

Jinan Keya Electron Science And Technology Co., Ltd. , https://www.keyaservo.com