Under typical conditions, the maximum difference in CPU temperature rise is 3.1 ° C, and the relative error is -9.6%. The error is mainly due to some simplified processing in the modeling process, and temperature measurement error. Overall, the results of numerical calculation can meet the needs of engineering analysis and design. Influence of heat transfer path In the initial design, there is no contact between the heat sink and the case, and the heat generated by the CPU is completely transferred to the case by convection in the closed cavity. In the improved design, thermal grease was added between the heat sink and the housing.
The heat transfer methods and paths of the two structures are different. Without silicone grease, the heat generated by the CPU is dissipated in natural convection and transferred to the housing. Due to the low heat exchange efficiency, a large temperature gradient is generated between the component and the air. The CPU temperature is as high as 155 ° C, which exceeds the component's Withstand range. When there is thermal grease, part of the heat generated by the CPU is transferred to the PCB, causing the temperature of the board and chips in the surrounding area to increase, and most of the heat is directly transferred to the device case through the silicone grease, and the temperature of the component Significantly decreased to only 49 ℃, indicating that the heat transfer path and method have a significant effect on the heat distribution of electronic products. It indicates that the temperature of the area where the device casing contacts the thermal grease is the highest, and the farther away, the lower the temperature. However, due to the good thermal conductivity of the shell material, the temperature gradient across the shell surface is not large, and the maximum temperature difference is only about 1.2 ° C.
The heat transfer path and method only slightly affect the temperature distribution, and the maximum temperature of the housing is basically the same. The heat transfer path and method in the confined space have a significant impact on the temperature field distribution of the device. The heat of the high-power components such as CPU is directly transferred to the housing, which can effectively reduce the temperature of the CPU and meet the thermal design requirements. Increasing the thermal conductivity of silicone grease can also reduce the CPU temperature, but the housing temperature remains unchanged. The temperature of the CPU and the case change linearly with the ambient temperature.
To provide uninterrupted supply of power in home, the V-Guard Digital UPS requires the best battery. The VT180 batteries, manufactured by V-Guard, are a perfect fit with the Digital UPS. These batteries also work effectively with other UPS. With a capacity of 180Ah C20 at 27degree C, these batteries offer backup that varies from three hours to fifty four hours depending on the connected load. With a length of 503mm, width of 188mm and height of 417mm, these batteries have a dry weight of 40Kg, filled weight of 64Kg and their gross weight is 66Kg. These batteries can hold 18.5litres of acid, more or less. These batteries come packed in multi coloured cartons. While there is the standard warranty of 36months, prorated warranty of 18months is also available. These are low maintenance batteries designed to provide up to 40% extra backup.
120Ah 12V Solar Battery,120Ah Solar Battery,Solar Battery
Yangzhou Bright Solar Solutions Co., Ltd. , https://www.cnbrightsolar.com