Solar street light pole
Garden light pole
Solar street lighting is consist of solar panel, battery, controller, lamp source and pole etc.
The solar souce can be choosed as your demand, such as LED, HFED, LPS, HID, LMH, energy saving lamp etc.
Application
The road, City Road, Pedestrian Lane, Squares, Schools, Parks, Gardens, Residential areas and other places of outdoor lighting.
1. LED
LED lamp shade is a transparent shade and made of polycarbonate plastic injection molding material, high strength, good light; Using LED as the light source, and LED is light emitting diodes, has the characteristics of high efficiency and long life. At present, the lamp is shaping up as a mainstream lighting products of new generation.
Power LED(80W)
Woking Voltage DC24V
General luminous: 8000lm
LED Luminous Efficiency: 100lm/W
Center illuminance: 20lx, Ra>80,
Color temperature: 2700-7000,
Protection Grade: IP65,
Working life >50000h, It can woke more than 10 years in accordance with 12 hours a day.
2. Battery
GEL battery
Advantage: The small self -discharge rate, the better deep discharge, Top charge acceptance, large capacity, strong start in low, the good shock resistant and Anti-temperature charge Production
3. Controller
PHOCOS CIS controller, waterproof, IP68
4. Solar panel
1). High 15-18% transfer efficiency of solar panel
2). Obtained CE TUV and so on, we keep authentication high consistent with standard testing in actual production.
3). 5 years' warranty, no less than 90% of standard output power within 10 years, 80% of standard output power within 25 years.
5. Street light pole
Best steel Q235, 3-14m height, hot dipped galvanization and spraying powder.
6. Packing: Woven bag for pole, carton and plywood case for other items
The Substation Fitting is mainly used for the connection of the bus down-lead of substation and the outlet terminal of electrical equipment (such as transformer, circuit breaker, isolating switch and mutual inductor). Because the outlet terminal of electrical equipment commonly made by copper and aluminum, while the bus down-lead is divided into aluminium strand wire or steel core aluminum strand wire, the equipment, by material, was into the aluminum and copper two series. According to the installation method and structure of the different equipment, the line clamp was divided into bolt type and compression type. Each type of wire clip is divided into three, listing as 0, 45 and 90 degrees according to the angle of the down-lead and the installation of the terminals from the electrical equipment.
Substation Fitting
Grid Line Fitting,Power Fitting For Substation,Transmission Line Hardware,Substation Cable Fitting,High Voltage Connector ,Insulated Clamps ,Straight Line Clamp
Jiangsu Chuandu Electrical Technology Co.,Ltd. , http://www.cdepf.com